RIDGID 17881 258 Cutter with No.700 Powerdrive 115 Volt 17881

The RIDGID 258 Power Pipe Cutter cuts 2 1⁄2 - 8in (65-200mm) schedule 10*/40 steel pipe, galvanized pipe, rigid conduit, etc. at the job site or in the shop. Powered by the RIDGID No. 700 Power Drive, the 258 is a displacement cutter that provides square cuts.

The operator controls the feeding rate by pumping the hydraulic foot pump throughout the operation. A square cut with minimal burr on either 21ft (6m) or nipple lengths of pipe is achieved quickly, without abrasive dust, sparks, or open flame.

Also, the RIDGID Pipe Roller for beveling can be used to rotate the pipe while second operator uses a grinder to bevel the pipe.

No Load Speed: 26-30/min.
Capacity: Schedule 10/40 Steel Pipe: 2.1⁄2 - 8in (65-200mm).
Weight: 48kg.